TL;DR:
How do I make the thermostat send a 'heat' request to the boiler without making the boiler use way too much gas?

Hi all,

I have a question about automating central heating. My current setup:

Ground floor:

• Main thermostat linked to boiler (Honeywell T6 on WiFi through Honeywell integration)
• One radiator with Sonoff TRV-ZB, zigbee
• Three radiators with non-smart knobs that are usually open
• The main room has a Sonoff Presence sensor

First floor:

• Three rooms that can be occupied with Sonoff TRV-ZBs.
• Two of three rooms have Sonoff Presence sensors

All rooms that can be heated smartly are controlled through a blueprint once shared here called 'Advanced heating control V5'.

I have a helper called 'Comfort Temp' which is a slider that controls the setpoint on the main thermostat and the TRV of an occupied room.

So the obvious question is: is there any good way to get the main thermostat to send a heating request to the boiler?

I've seen something about a WiFi module that you can put in between the main thermostat and the boiler that offers more control (Nodo OpenTherm Gateway, OTGW). Does anyone have experience with this?
Or do I solve this with more TRVs on my ground floor? I've heard about central heating systems not enjoying a fully thermostatic valved circuit. More TRVs also means I have to replace the valves on a couple of radiators.

Any advice would be greatly appreciated!