| Post Reply | RetroFed Forum Forum Index » 3DPrinting |
| Author | Message | ||
|---|---|---|---|
soulsource
discuss.tchncs.de
soulsource@discuss.tchncs.deJoined: 2023-06-15 |
Hi! I'm hoping someone else has run into the same issue and can give me some hints what I might try to fix this. My problem is that over time, the z-axis positioning of my relatively new Elegoo Neptune 4 Max seems to become slightly unstable. That is, after I level the bed and adjust the z-offset, everything looks fine. However, if I move up and down by a couple of centimeters for a few times, the z-offset is wrong again. Due to this, I had to restart quite a few prints now, because wrong z-offset leads to a bad first layer. Now I wonder what I should attempt first in order to fix this? |
||
| 1 Original | |||
| Post Reply |
Back to top |