| Post Reply | RetroFed Forum Forum Index » FOSSCAD |
| Author | Message | ||
|---|---|---|---|
|
olee1420
fosscad.io
olee1420@fosscad.io Joined: 2026-02-27 |
I printed the standard mp5k leber housing but my ap5p has the new larger denial block and isn’t able to fit it. I’ve got an AS Designs ARC fire that I want to use in it so I’m looking for a file to accommodate the new denial block as well as a cutout for the arc fire (it’s the non-Ambi) right side selector one |
||
| 3 Original | |||
sado
Moderator
sado@lemmy.mlJoined: 2025-09-28 |
Is the denial block interfering with the lower itself? Typically you just need clearance for the trip. It is recommended to modify the trip vs. modifying the denial block, for reasons. |
||
| 2 | |||
|
olee1420
fosscad.io
olee1420@fosscad.io Joined: 2026-02-27 |
Is the denial block interfering with the lower itself? Typically you just need clearance for the trip. It is recommended to modify the trip vs. modifying the denial block, for reasons.
Yes the denial block prevents the lower from fully lining up with the rear pin hole |
||
| 1 | |||
|
sado
Moderator
sado@lemmy.ml Joined: 2025-09-28 |
Yes the denial block prevents the lower from fully lining up with the rear pin hole
Do you have pictures? |
||
| 1 | |||
| Post Reply |
Back to top |