Link: https://slrpnk.net/api/v3/image_proxy?url=https%3A%2F%2Flemmy.dbzer0.com%2Fpictrs%2Fimage%2F81b3570f-e6bb-4269-bc10-51a46c2669a8.webp

I need to connect a PC to my washing machine. The washing machine has a bank of pins labelled like this:

• 0v
• tx
• rx
• 5v

The microcontroller is an ATmega32L, which has specs for the serial connection as follows:

My USB to TTL serial adapter is apparently based on a ch340 chip. It looks almost exactly like the pic I attached, except mine does not have a crystal on it because I think the chip has an embedded clock. The important thing is the pins match my adapter.

My knee-jerk thought was to connect it as follows:

adapter → washing machine PCB

gnd → 0v
rxd → tx
txd → rx
3v3 → (nothing)
5v → 5v ← bad idea?

(with s1 jumped to 5v on the adapter)

Someone told me I should not connect 5v to 5v. I was assuming one connection needed 5v and the other supplied it, but I was told they are both supplying 5v, but not perfectly 5v, so the difference will strain something and cause damage.

So how should I hook this up?

update (I’m stuffed?)

I heard washing machine manufacturers often sabotage the serial ports before shipping as an anti-repair tactic. I thought my old machine might pre-date that practice, but I might be wrong. I metered TX voltage against 0v using a crappy cheap DMM. Results:

0.01, 0.00, 0.01, 0.00, 0.01, 0.00, 0.01, 0.00, … etc, every second or so.

Looked encouraging, as if there is activity. Then I metered 0v against 5v:

~~0.01, 0.00, 0.01, 0.00, 0.01, 0.00, 0.01, 0.00, … etc, every second or so.

Yikes. I was expecting that to read a steady 5v. Due to bad wiring in the house, I think that is just noise on the ground wire. And apparently the serial port is dead.

I had the two 5v lines connected to each other for a while, so it’s possible I damaged it, if not the manufacturer.~~

Update 2: I have 5v, so the port may work

It turns out I had a bad alligator clip, so of course I got a flat reading. The 5v pin on the serial port gives 5v. Thus I might have a live port. Now how do I use it?